Robosol

RoboSol

Suggested User Instructions for the RoboSol Automatic Aerosol Dispenser

Please read these instructions carefully and retain for future reference.

A single dispenser should suffice for an average sized home of 150M3. You may need an additional dispenser for large residences or premises.

Using For the First Time

Choose a central location where air currents are likely to circulate and preferably close to the area where insect pests are most prevalent. You may need to test more than one location.

Shelf Placement or Wall Hanging

Select a position at least 2 metres above the floor and not closer than 300mm from the ceiling. For wall hanging use the bracket provided (warning do not over-tighten the screws into gib or plaster board). Avoid installation over furniture and polished surfaces.

Installing a New Battery.

Unscrew the dispenser from the can and clip a 3*3A battery on to the battery snap.

2 Year Warranty

Your RoboSol automatic aerosol dispenser must be maintained according to the above instructions.

Within the warranty period of 2 years from the date of purchase, we will eliminate, free of charge, any defects in the dispenser resulting from defects in materials or workmanship, either by repairing or exchanging the dispenser as we may determine.

Not covered in this warranty is deliberate misuse, breakage, normal wear and tear, and defects which have a negligible effect on the value or operational the dispenser. The warranty becomes void if repairs are attempted or undertaken by unauthorised persons, and/or genuine RoboSol parts are not used, and/or RoboSol genuine replacement cans are not used.

This warranty in no way affects your rights under statutory law. Our liability shall not exceed the cost of the replacement dispenser and in no case shall be held liable for any consequential loss or damage or negligence resulting from the use of the dispenser or aerosol cans. Our liability for failing to perform, or adequately perform, the warranty obligations is similarly limited. The warranty does not include dispenser performance or battery life.

If faults develop please return immediately (without the can) to your supplier or directly to us, freight prepaid.

Installing a New Can

Shake the can. Holding the dispenser upright and pointing it away from you, push the button on the top down until the dispenser pulses and dispenses.

Prime by doing this about 10 times until a steady flow of material is dispensed with each pulse. Then PUSH THE ON BUTTON DOWN UNTIL IT STAYS DOWN.

The dispenser will now operate automatically. To turn the dispenser off, push the button until it releases and comes back up.